20K, and FLEX 10KE JTAG configuration, or MAX 7000A and. JTAG cable for connection to a standard JTAG 20-pin 2. The ByteBlasterMV VCC pin must be connected to 3.3 V for APEX II, Mercury, ACEX 1K, APEX.1.65 V to 3.6 V application voltage support on the JTAG/SWD interface and 5 V tolerant inputs.JTAG/serial wire debug (SWD) specific features:.Depending on your JTAG tool, youd need a 20-pin to 14-pin TI adapter. This is the same header interface as used in other TI products and is NOT the standard 14 pin ARM layout. cJTAG (IEEE 1149.7) is an extension to the JTAG standard (IEEE 1149.1). SWIM cable for connection to an application with pin headers or 2.54 mm pitch connector For JTAG pin out see section 8.16 of BeagleBoard HW Reference Manual (rev. While it may look like it (reduced pin count on the debug header), cJTAG is not SWD.SWIM cable for connection to an application with an ERNI standard connector Vertical connector reference: 284697 or 214017 Horizontal connector reference: 214012.SWIM programming speed rates: 9.7 kbyte/s in low-speed, 12.8 kbyte/s in high-speed XDS200 is the midrange class of JTAG debuggers for Texas Instruments microcontrollers and embedded processors.SWIM low-speed and high-speed modes support.1.65 V to 5.5 V application voltage support on the SWIM interface.USB 2.0 full-speed compatible interface.
0 kommentar(er)
